Meiko DV 270.2 - User Manual

Questions and Answers

D
Douglas FloresAug 20, 2025
How to reset factory setting parameter list on Meiko Dishwasher?
- M
  Megan ScottAug 20, 2025
  To set parameters back to factory settings on your Meiko Dishwasher, switch the power supply OFF and then ON within 5 minutes.
G
garciastevenAug 22, 2025
Why does my Meiko DV 270.2 say 'Emergency program active Restricted washing possible'?
- P
  philip55Aug 22, 2025
  If the Meiko Dishwasher displays 'Emergency program active Restricted washing possible,' it indicates an issue with either the boiler/tank heating or the fresh water supply. Check the system to identify the exact cause.
A
ambermunozAug 25, 2025
What does 'Regeneration in progress' mean on my Meiko DV 270.2?
- A
  Anthony JonesAug 25, 2025
  The Meiko Dishwasher regeneration program has started and is currently running. You can pause the program, but you cannot cancel it.
S
Sandra FosterAug 26, 2025
What to do if my Meiko DV 270.2 Dishwasher says 'Regeneration necessary'?
- K
  Katie LewisAug 27, 2025
  The Meiko Dishwasher requires regeneration. The user must start the regeneration by emptying the tank and adding salt.
K
kelli26Aug 28, 2025
What to do if the hood of my Meiko DV 270.2 is not closed?
- T
  Taylor Lester DVMAug 28, 2025
  If the hood of the Meiko Dishwasher is not closed, check the connection S1, change the microswitch, check the microswitch adjustment or replace the defective I/O circuit board.
S
Stephanie SharpAug 30, 2025
What to do if my Meiko Dishwasher says 'Incorrect password / no authorization'?
- C
  Christian WalkerAug 30, 2025
  If you enter an incorrect password or lack authorization on the Meiko Dishwasher, enter the code once again.
R
Ryan JonesSep 1, 2025
Why does my Meiko DV 270.2 say maintenance is required?
- T
  Tony RomeroSep 1, 2025
  Your Meiko Dishwasher indicates that maintenance is required because the set operating hours (P122) or batch number (P123) has been reached. Inform the service department and perform maintenance. After maintenance, reset the maintenance counter (P124).
H
hernandeznicoleSep 3, 2025
What to do if my Meiko DV 270.2 hood is not closed?
- E
  emily25Sep 3, 2025
  If the hood of your Meiko Dishwasher is not closed, you should check connection S1, check the microswitch adjustment, change the microswitch or replace a defective I/O circuit board.
A
Annette CervantesSep 5, 2025
What to do if my Meiko Dishwasher asks for factory setting parameter list?
- E
  enelsonSep 5, 2025
  To address the 'Factory setting parameter list' message on your Meiko Dishwasher, switch the power supply ON/OFF within 5 minutes and set parameters back to factory settings. This action will be rejected, and parameters will be retained and Information 123 will disappear.
E
Emily MatthewsSep 7, 2025
How to resolve the 'Incorrect password / no authorization' error on my Meiko DV 270.2?
- D
  Daniel MaddenSep 7, 2025
  To resolve the 'Incorrect password / no authorization' error on your Meiko Dishwasher, enter the code once again.