To Next Page
P
Paula PenaAug 20, 2025
How to reset factory setting parameter list on Meiko FV 250.2 Dishwasher?
- AaballAug 20, 2025
To set parameters back to factory settings on your Meiko Dishwasher, switch the power supply OFF and then ON within 5 minutes.
How to reset factory setting parameter list on Meiko FV 250.2 Dishwasher?
To set parameters back to factory settings on your Meiko Dishwasher, switch the power supply OFF and then ON within 5 minutes.
Why does my Meiko Dishwasher say 'Emergency program active Restricted washing possible'?
If the Meiko Dishwasher displays 'Emergency program active Restricted washing possible,' it indicates an issue with either the boiler/tank heating or the fresh water supply. Check the system to identify the exact cause.
What does 'Regeneration in progress' mean on my Meiko FV 250.2 Dishwasher?
The Meiko Dishwasher regeneration program has started and is currently running. You can pause the program, but you cannot cancel it.
What to do if my Meiko Dishwasher says 'Regeneration necessary'?
The Meiko Dishwasher requires regeneration. The user must start the regeneration by emptying the tank and adding salt.
What to do if the hood of my Meiko FV 250.2 Dishwasher is not closed?
If the hood of the Meiko Dishwasher is not closed, check the connection S1, change the microswitch, check the microswitch adjustment or replace the defective I/O circuit board.
What to do if my Meiko FV 250.2 Dishwasher says 'Incorrect password / no authorization'?
If you enter an incorrect password or lack authorization on the Meiko Dishwasher, enter the code once again.
Why does my Meiko FV 250.2 Dishwasher say maintenance is required?
Your Meiko Dishwasher indicates that maintenance is required because the set operating hours (P122) or batch number (P123) has been reached. Inform the service department and perform maintenance. After maintenance, reset the maintenance counter (P124).
What to do if my Meiko Dishwasher hood is not closed?
If the hood of your Meiko Dishwasher is not closed, you should check connection S1, check the microswitch adjustment, change the microswitch or replace a defective I/O circuit board.
What to do if my Meiko FV 250.2 Dishwasher asks for factory setting parameter list?
To address the 'Factory setting parameter list' message on your Meiko Dishwasher, switch the power supply ON/OFF within 5 minutes and set parameters back to factory settings. This action will be rejected, and parameters will be retained and Information 123 will disappear.
How to resolve the 'Incorrect password / no authorization' error on my Meiko FV 250.2 Dishwasher?
To resolve the 'Incorrect password / no authorization' error on your Meiko Dishwasher, enter the code once again.
General| Brand | Meiko |
|---|---|
| Model | FV 250.2 |
| Category | Dishwasher |
| Language | English |
