6
Remember to note down always the 4-digit code for the appliances, located under the battery cover,
when the search and programming are complete.
The codes will be required if the remote control must be re-programmed following accidental deletion.
To find the code for your remote control:
1. Hold down the selection key for the appliance to be programmed for 5 seconds (
TV
...
ADSL
), until the light
indicator at the top starts to flash indicating that the remote control is ready for programming.
2. Upon release insert the code number you noted beforehand. Three flashes indicate that the code has
been memorized correctly. If not, try the code entry procedure again from point 1.
PROGRAMMED CODE NOTING
1. Press the select key for which you want to know the code and hold down for 5 seconds (
TV
...
ADSL
), until the
light indicator at the top starts to flash indicating that the remote control is ready for programming.
2. Release the selection key and within 8 seconds press and release the key.
3. After a few seconds, the light indicator communicates the code you are looking for by flashing the four
numbers separately. Count the number of flashes for each code number. For example, for the code 1306,
the key flashes one, three, ten and six times to give:
= 1
= 3
= 0
= 6
4. Make a note of the code on the adhesive label inside the battery cover for quick and easy future
reprogramming.
RE-PROGRAMMING YOUR REMOTE CONTROL BY ENTERING
THE CODE NOTED DOWN
TROUBLESHOOTING
PROBLEM
The appliance does not respond and the
light indicator does not light up when a key is
pressed.
The appliance does not respond but the light
indicator lights up.
When you press a key the light indicator
flashes and the appliance does not respond
to commands.
The remote control commands are not all
working correctly.
The code for your appliance brand is not in the
list of codes of the end of this booklet.
SOLUTION
Check that the batteries are fitted correctly.
If necessary, replace them with 2 new 1.5 V
AAA/LR03 alkaline batteries.
Check that the batteries are new and that the
remote control is pointing at the TV without
any obstacles in the way. If required, reset the
remote control code, following programming
procedure
A
or
B
.
The batteries are low. Change them.
You may have used the wrong code. Reset
the remote control by repeating programming
procedure
A
or
B
.
Set the remote control code, following the glo-
bal search programming procedure
B
.
2 year WARRANTY - The warranty is declared null and void if the product is tampered with or used improperly.
If you have further questions concerning the FULLY 8 remote control unit, visit www.fully8.com to find all the
information you need quickly and easily.
To Next Page
Loading...
