1.Make sure that the TV is
ON.
2.Hold down the and
keys simultaneously until
the light indicator at the top
starts to flash indicating
that the remote control is
in programming mode.
3.Release the keys, point the
remote control at your TV
and press and release the
key, slowly several
times. STOP when your TV
goes OFF.
4.When your TV is OFF,
press the and keys
simultaneously. When you
release the keys, three
flashes indicate that the
search operation has been
completed correctly.
5.
IF YOU DO NOT HAVE THE
PROGRAMME SELECTION
KEYS ON YOUR ORIGINAL
REMOTE CONTROL
If your original remote
control does not have the
programme selection keys
This operation may take a few minutes.
Identify and take note of the TV code which you have
searched for, following the code noting procedure
(see "PROGRAMMED CODE NOTING" section)
.
NOTE:
DURING THE SEARCH OPERATION, THE LIGHT INDICATOR
FLASHES MORE QUICKLY.
THE LIGHT INDICATOR STOPS FLASHING.
The remote control leaves the programming mode and the
light indicator stops flashing:
•
if no keys are pressed for 12 seconds
•
if an invalid brand code is entered
•
if you press keys other than those indicated
•
if the code search list is completed.
In this case, switch to programming mode B .
(e.g. / , +/-, CH+/-
..etc), once you have
programmed Speedy,
you can still select the
programmes from 0 to 9,
as follows:
• Hold down the and
keys simultaneously until
the light indicator at the top
starts to flash indicating
that the remote control is
in programming mode.
• Release the keys and
press 8 times within
12 seconds.
Three flashes indicate that
the operation has been
completed correctly.
• Make sure you can change
programmes from 0 to 9
using the and keys.
If not, repeat the search
operation, starting from
point 2.
P
-
+
P
AV
GLOBAL SEARCH REMOTE CONTROL
PROGRAMMING
B
Additional check
Check that all 7 keys are operating correctly. If the
commands work incorrectly or erratically, you have probably
entered a code for a similar but different remote control.
In this case, repeat the search procedure from point 3 until
all keys respond correctly to the commands sent.
If you cannot find the right code after several attempts,
switch to programming mode B .
AV
AV
P
-
+
P
+
P
To Next Page
Loading...
