Basic operation
46
GB
Filling with coee beans
1. Open the lid of the 2-chamber bean
container(2).
2. Fill coee beans into the bean cham-
bers.
3. Close the lid of the 2-chamber bean
container.
The "BEANSELECT" button (30)
(BARISTATS model) or the "BeanSelect"
slider (3)(BARISTAT model) can be used
to select a bean type prior to preparation
(see section5.6, page49).
4.6 Using ground coee
Ground coee may also be used to pre-
pare coee beverages.
ATTENTION
The use of unsuitable types of coee can
lead to clogging of the brewing unit.
Do not use any instant products.
Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
4
Fig. 10: Ground coee chute
1. Open the lid of the ground coee
chute(4).
2. Use the enclosed coee spoon for
dosing.
Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
3. Close the lid of the ground coee
chute.
4. Proceed as described in sections 5 to 7.
Information
Two-cup dispensing is not possible
when using ground coee.
If no coee is prepared within 3
minutes of opening the ground coee
chute, the appliance switches to opera-
tion with coee beans and the ground
coee is discharged into the coee
grounds container.
4.7 Filling with water
Only use fresh, cold water without carbon
dioxide for optimum coee enjoyment.
Change the water daily.
Information
The quality of the water largely determines
the avour of the coee. Therefore, use a
water lter (see section9.8, page60 and
section9.9, page60).
1
Fig. 11: Water tank
1. Open the lid of the water tank and pull
the water tank (1) upwards out of the
appliance by the handle.
2. Fill the water tank with water.
Note the maximum capacity of 1.8
litres.
3. Insert the water tank into the appliance
from above and close the lid.
To Next Page
Loading...
Need help?
General
