Melitta Cafina XT4 - Operating Parameters for Instant

10-30 Melitta Cana XT4 Touch Display Service Manual V1.0 -270320
PWM foam
standard
24 %
The PWM control value for warm foam in
%.
• Decreasing value = foam rmer and
temperature higher
• Increasing value = foam less rm and
less warm
Calibrate milk
system
PWM foam
hot
22 %
The PWM control value for hot foam in %.
• Decreasing value = foam rmer and
temperature higher
• Increasing value = foam less rm and
less warm
Calibrate milk
system
Operating parameters for
instant
Description Options / default
Instant 1
Delivery rate
48 g/s
The delivery rate for the various instant
powders used in instant container 1 can
be entered here.
Weigh out
Instant 2
Delivery rate
37 g/s
The delivery rate for the various instant
powders used in instant container 2 can
be entered here.
Weigh out
Instant 1
Container volume
1000 g
The capacity of instant container 1 can be
entered here.
550 g
Instant 2
Container volume
1000 g
The capacity of instant container 2 can be
entered here.
550 g
Instant 1
Min. PWM
7%
Minimum value for the PWM so instant
motor 1 can start up under load without
problems. Please do not change these
values.
7 %
Instant 2
Min. PWM
7%
Minimum value for the PWM so instant
motor 2 can start up under load without
problems. Please do not change these
values.
7 %
Parameters for Water lter Description Options / default
Filter monitoring
---
Here you can dene whether lter moni-
toring should be active. If lter monitoring
is activated, the co󰀨ee machine noties
the user that the water lter is due to be
changed when the entered date is reached,
or if the remaining lter capacity reaches
0 l (whichever comes rst).
---
Next lter change
01.09.2020
If lter monitoring is active, you can enter
the date of the next water lter replace-
ment here. Click on the date eld to open
a calendar selection menu.
---
Remaining capacity
8000 l
You can enter the remaining capacity of
the water lter in liters here. See the corre-
sponding tables from the lter manufacturer
for the relevant values.
---
Parameters for Pre-heating Description Options / default