Melitta Latticia OT User Manual

First steps
22
GB
2.1 "On/O" button
Switch on the appliance by briey pressing
the "On/O" button. The appliance per-
forms automatic rinsing while it heats up.
Place a vessel under the outlet if possible.
You can switch o the appliance by press-
ing the "On/O" button for approximately
2seconds. If you do not switch o the
appliance, it will switch o automatically
after a dened o time.
2.2 Service modes
The appliance has two service modes. The
service modes allow you to congure your
appliance and use care and maintenance
functions.
Calling up service mode


Press the "Water/Service" button
for longer than 2seconds to access
Service mode1.
 
Simultaneously press the
"Water/Service" and "Brewing Strength"
buttons for longer than 2seconds to
access Service mode2.
»

The Ready display ashes rapidly
when the service mode is active.


Press the "Water/Service" but-
ton once or several times to select a
function.
» The display for the active function is
lit up.
If no further input is made within 1minute,
the appliance returns to Ready mode.
Ending service mode

Press the "Water/Service" button
for more than 2seconds to save the
setting and exit service mode.
 Press any direct key to exit service mode
without saving the setting.
3 First steps
3.1 Unpacking the appliance
Remove the packaging material, the adhe-
sive strips and the protective lms from
the appliance. Please keep the original
packaging.
The appliance has been tested in the
factory to ensure that it functions perfectly.
Therefore, the appliance may still contain
traces of coee and water.
Included in delivery
 Milk hose
 Screwing aid for the water lter
 Test strip for determining the water
hardness
3.2 Setting up the appliance
 Set up the appliance in a dry room.
 Set up the appliance on a stable, at
and dry surface. The surface may not be
hot. The appliance may not be placed in
the vicinity of sinks or the like.
 Set up the appliance at a sucient
distance (approx. 10cm) from the wall
and other objects. The space above the
appliance should be at least 20cm.
 Route the power cable so it does not lie
over edges or cannot be damaged by
hot surfaces.
3.3 Connecting the appliance
Only connect the appliance to a properly
installed earthing contact socket. The
earthing contact socket must be protected
by a fuse with a rating of at least 10 A.
3.4 Switching on the appliance
for the rst time
1. Place a vessel under the height-adjust-
able outlet. The distance between the
outlet and the vessel should be as small
as possible.
2. Switch on the appliance with the "On/
O" button.
»

The Ready display lights up briey.
»

The Water display lights up.
3. Remove the water tank. Rinse out the
water tank with clean tap water.
4. Fill the water tank with fresh, cold tap
water and insert it. Observe the instruc-
tions in section4.1, page23.

Melitta Latticia OT Specifications

General

Type	Automatic Coffee Machine
Milk System	Integrated Milk Container
Pump Pressure	15 bar
Power	1450 W
Brand	Melitta
Model	Latticia OT
Color	Black
Voltage	220-240 V
Bean Container Capacity	250 grams
One-Touch Functions	Cappuccino, Latte Macchiato, Espresso
Material	Plastic