Basic settings
25
Information Do not set the grinding
neness too ne. The optimum grinding
neness is set when the coee ows
evenly out of the outlet producing a
ne, dense crema.
6 Basic settings
You will nd the basic settings in Service
mode1. The number of illuminated coee
beans indicates the set value.
6.1 Setting switch-o time
If you do not operate the appliance for a
long time, it initially switches to energy
save mode. The appliance switches o
completely later on.
If the appliance is in energy save mode,
you can wake it up by pressing any button
briey.
1.
Press the "Water/Service" button
for longer than 2seconds.
2.
Press the "Water/Service"
button repeatedly until the 2x display
lights up.
3.
Press the "Brewing Strength"
button repeatedly until the desired time
is set.
4.
Press the "Water/Service" button
for more than 2seconds to save the
setting and exit service mode.
Press any direct key to exit service mode
without saving the setting.
Display Energy save mode
after:
Switch o after:
3 minutes 30 minutes
10 minutes 1 hour
20 minutes 4 hours
ashing
30 minutes 8 hours
6.2 Setting the water hardness
The hardness of the tap water inu-
ences how often you have to descale the
appliance. The harder the tap water, the
more frequently you have to descale the
appliance.
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip and the information
in the following table.
Water hardness °d °e °f
Soft 0to10 0to13 0to18
Medium 10to15 13to19 18to27
Hard 15to20 19to25 27to36
Very hard > 20 > 25 > 36
1.
Press the "Water/Service" button
for longer than 2seconds.
2.
Press the "Water/Service" but-
ton repeatedly until the Water display
lights up.
3.
Press the "Brewing Strength" but-
ton repeatedly until the required water
hardness is set.
4.
Press the "Water/Service" button
for more than 2seconds to save the
setting and exit service mode.
Press any direct key to exit service mode
without saving the setting.
To Next Page
Loading...
