What to do if cleaning or descaling is interrupted on Melitta CAFFEO LATTEA Coffee Maker?
If the cleaning or descaling process was interrupted due to a power outage, the appliance will perform a rinsing program automatically. Follow the appliance instructions to complete this process.
What to do if Melitta CAFFEO LATTEA Coffee Maker coffee does not flow?
If coffee does not flow, ensure the water tank is filled and correctly inserted. If needed, open the milk shower until water flows out, then close it. Also, the brewing unit might be obstructed, so clean it.
Why does my Melitta Coffee Maker only drip coffee?
If your coffee only drips through, the grinding fineness might be too fine. Set the grinding fineness coarser. Additionally, clean the brewing unit, and if necessary, run the integrated descaling and cleaning programs.
What to do if Melitta CAFFEO LATTEA grinder does not grind?
If the grinder isn't grinding, tap lightly on the bean container, as the beans might not be dropping into the grinder because they are too oily. If that doesn't work, call the hotline, because there might be foreign objects in the grinder.
What does it mean when all buttons are flashing on my Melitta CAFFEO LATTEA Coffee Maker?
Continuous flashing of all buttons indicates a system error. Try switching the appliance off and on again using the ON/OFF button. If the problem persists, the appliance needs to be serviced.
What to do if I cannot reinsert the brewing unit in my Melitta CAFFEO LATTEA?
If you cannot reinsert the brewing unit, check that the handle for locking the brewing unit is correctly engaged. If that doesn't work, switch the appliance off and on again, then simultaneously press the one- and two-cup dispensing buttons for more than 2 seconds to move the actuator into position. Then, reinsert the brewing unit and ensure it's correctly locked.
Why is my Melitta CAFFEO LATTEA Coffee Maker grinder so loud?
If there is a loud grinder noise, call the hotline, because there might be foreign objects in the grinder.
What does it mean when the bean symbols flash on my Melitta CAFFEO LATTEA?
If the bean symbols flash even though the bean container is full, there may be an insufficient quantity of ground beans in the brewing chamber. Press the button for one-cup dispensing or two-cup dispensing.
Why are cleaning and stand-by symbols flashing on my Melitta CAFFEO LATTEA?
If the symbols for cleaning and stand-by flash alternately, the brewing unit is either missing or not properly inserted. Ensure the brewing unit is correctly inserted. Alternatively, the brewing chamber may be overfilled. Switch the appliance off and on again via the ON/OFF button (repeat if necessary) until standby mode is displayed.
What does it mean when the milk shower symbol is illuminated out of sequence on Melitta Coffee Maker?
If the symbol for the milk shower is illuminated out of sequence, there may be air in the lines inside the appliance. Open the valve until the symbol goes out, then close it again. Switch off the appliance, remove the brewing unit, clean it under running water, and reinsert it. Switch the appliance back on and dispense a larger amount of coffee.
General| Type | Coffee/Espresso |
|---|---|
| Product color | Black, Purple |
| Removable water tank | Yes |
| Product type | Espresso machine |
| Coffee input type | Coffee beans |
| Coffee maker type | Fully-auto |
| Appliance placement | Countertop |
| Water tank capacity | 1.2 L |
| Multi beverage | No |
Explains the meaning of symbols used for warnings, cautions, and notes.
Defines the proper and intended purposes of the appliance.
Describes improper uses and potential hazards associated with misuse.
Identifies and explains the numbered parts of the appliance diagram.
Explains the symbols and their meanings shown on the appliance's display.
Instructions for placing and preparing the appliance before initial use.
Steps for connecting the appliance to a power source and electrical safety.
Guidance on how to fill the coffee bean hopper correctly.
Instructions for cleaning the milk canister before first use.
Steps for filling the water reservoir with fresh tap water.
Procedure for the initial activation and priming of the appliance.
How to set the amount of coffee dispensed per cup.
Instructions for selecting the desired coffee strength.
Steps to power on the coffee maker and its initial rinse cycle.
Procedure for powering down the coffee maker and its rinse cycle.
Step-by-step guide to making a single serving of espresso or caf cr me.
Step-by-step guide to making two servings of espresso or caf cr me.
How to measure and set the water hardness for optimal performance.
Setting the timer for the appliance's energy-saving feature.
Configuring the automatic shut-off timer for power saving.
Adjusting the temperature at which coffee is brewed.
Restoring the appliance to its original factory settings.
Adjusting the coarseness of the coffee grind.
Instructions for routine external and internal cleaning of the appliance.
Detailed steps for cleaning the removable brewing unit.
How to run the automatic cleaning cycle for internal residue removal.
Instructions for running the automatic descaling cycle to remove limescale.
Steps to prepare the appliance for storage or moving, including venting.
To Next Page
