Melitta CAFFEO LATTEA User Manual

66
11.3 Integrated cleaning programme
The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning symbol ashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off“
on page 51).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning lights up on the display.
– Only use Melitta
®
cleaning tabs for fully automatic coffee makers.
These cleaning tabs are specically designed for the Melitta
®
CAFFEO
®
LATTEA
®
. The use of other cleaning agents can damage the appliance.
Run the integrated cleaning programme as follows:
1 Open up the ap of the water tank (Fig. A, no. 7) and pull the water tank
up and out of the appliance. Fill the water tank to the max. mark with
fresh tap water and reinsert it.
2 Simultaneously press both the button for one-cup dispensing and
the ON/OFF button for about 3 seconds.
→ The symbol for cleaning ashes.
The drip tray symbol illuminates.
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, one bean symbol is shown on the display.
→ First, two automatic rinsing processes are carried out. Afterward, the
standby symbol illuminates.
5 Reach into the recess on the right side of the appliance (Fig. A, no. 14)
and pull off the cover to the right.

Melitta CAFFEO LATTEA Specifications

General

Type	Coffee/Espresso
Product color	Black, Purple
Removable water tank	Yes
Product type	Espresso machine
Coffee input type	Coffee beans
Coffee maker type	Fully-auto
Appliance placement	Countertop
Water tank capacity	1.2 L
Multi beverage	No