ENGLISH
49
4.5 Filling the water tank
• Open up the ap of the water tank (Fig. A, no. 7) and pull the water tank
up and out of the appliance.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
Note
If the water tank runs empty during operation (e.g. during the coffee dispensing
process), the symbol for the water tank will be illuminated. The current
operation will be stopped and the water tank must be lled before starting a
new operation.
4.6 Switching on for the rst time
All of the tubes have been drained and aired out at the factory. For this reason, the
rst time the appliance is switched on, the symbol for the milk shower will be
illuminated after the heat-up phase and the appliance must be vented via the milk
shower.
Caution!
The appliance may only be vented without the Melitta
®
Claris
®
water lter and
with a full water tank.
– Insert the Melitta
®
Claris
®
water lter into the water tank only after venting.
– Fill the water tank with fresh tap water to the max. mark before venting.
• Press the ON/OFF button to switch the appliance on.
→ The standby symbol is ashing. The appliance heats up.
After heating up, the symbol for the milk shower will be illuminated.
• Remove the milk canister and place a larger vessel under the milk
shower.
• Turn the rotary switch for the milk shower (Fig. A, no. 11) clockwise to
open the milk shower.
→ The symbol for the milk shower is ashing. Water runs into the vessel
under the milk shower.
To Next Page
Loading...
Need help?
General
