Rev 1.1
Mellanox Technologies
108
Appendix B: Safety Warnings
Below is a list of safety warnings in English. For safety warnings in other languages, please refer
to the appendices in this manual.
1. Installation Instructions
2. Over-temperature
3. During Lightning - Electrical Hazard
4. Copper Cable Connecting/Disconnecting
5. Equipment Installation
6. Equipment Disposal
7. Local and National Electrical Codes
8. Hazardous Radiation Exposure
Read all installation instructions before connecting the equipment to the power source.
This equipment should not be operated in an area with an ambient temperature exceed-
ing the maximum recommended according to the Dell server.
During periods of lightning activity, do not work on the equipment or connect or dis-
connect cables.
Some copper cables are heavy and not flexible, as such they should be carefully
attached to or detached from the connectors. Refer to the cable manufacturer for spe-
cial warnings and instructions.
This equipment should be installed, replaced, or serviced only by qualified personnel.
Disposal of this equipment should be in accordance to all national laws and regula-
tions.
This equipment should be installed in compliance with local and national electrical
codes.
Caution – Use of controls or adjustment or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
To Next Page
Loading...
Need help?
General
