Mellanox Technologies ConnectX-4 Lx Firmware Release Notes

Rev 14.14.2036
Mellanox Technologies
27
- Description: Boot over VLAN with IB port is currently not supported.
WA: N/A
Keywords: PXE Boot
- Description: Some faulty boot loaders do not close the underlying UNDI device which
may result in unexpected behavior and possible system crash after the OS starts to load.
WA: N/A
Keywords: PXE Boot
- Description: Chain-loading gPXE stack may result in undesirable behavior.
WA: N/A
Keywords: PXE Boot
647143 Description: Executing a partial boot loop while only downloading the NBP and select-
ing localboot is unsupported and may cause undefined behavior.
WA: N/A
Keywords: PXE Boot
670421 Description: Using filename for PXE boot with rootpath for hooking an iSCSI target (to
install) is not supported when the PXE boot loader uses UNDI API, since all traffic must
get to the boot loader.
WA: N/A
Keywords: PXE Boot
- Description: iSCSI over IB is not tested.
WA: N/A
Keywords: iSCSI
- Description: iSCSI over DCB is not supported.
WA: N/A
Keywords: iSCSI
- Description: FlexBoot supports only a single active iSCSI connection. Thus, when
iSCSI-boot via Port 1 succeeds to connect but fails to boot, it will fail to connect via Port
2.
WA: N/A
Keywords: iSCSI
Table 16 - FlexBoot Known Issues
Internal Ref. Issue

Mellanox Technologies ConnectX-4 Lx Specifications

General

Brand	Mellanox Technologies
Model	ConnectX-4 Lx
Category	Adapter
Language	English