Rev 1.0
Mellanox Technologies
7
You have entered the following information:
1. Hostname: <bridge-1>
2. Use DHCP on eth0 interface? : yes
3. Admin password (Enter to leave
unchanged): (CHANGED)
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the “configuration
jump-start” command from configuration mode. Launching CLI...
bridge-1 >
The wizard displays a summary
of your choices and then asks you
to confirm the choices or to re-
edit them.
Either press <Enter> to save
changes and exit, or enter the
configuration step number (1, 2
or 3) that you wish to return to.
Note:
To run the command "configura-
tion jump-start, you must be in
Config mode.
Table 4 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example) Comments
To Next Page
Loading...
