Mellanox Technologies IS5030 User Manual

Mellanox Technologies Inc. 350 Oakmead Parkway, Sunnyvale, CA 94085 Tel: 408-970-3400 Fax: 408-970-3403 www.mellanox.com
IS5025/5030/5035 Installation Guide
Document Number
3135
Rev 1.0
Installing the Switch in the Rack
Minimum and Maximum Rack Depth for these switches
Make sure that the Installation kit you have is compatible with your rack.
To use the IS50XX series switch in a rack deeper than 50cm, order the switch with the standard
depth, or order the MIS000083 installation kit. The both of these solutions will allow you to install
the switch in a 19” rack whose vertical supports are between 50cm and 80cm apart.
Table 1 - Switches and Rail Kits for Various Rack Depths
Table 2 - Mellanox Part Numbering Legend
Place Field Decoder
IS
System Type InfiniScale Switch
50
Model Family
FF
Form factor 25 = 36 Ports Unmanaged
30 = 36 Ports and Chassis Management with limited
Fabri
c Management
35 = 36 ports and Fabric Management
C
InfiniBand Port
Config.
Q= QDR, D= DDR
-
Separator
P
# of Power
Suplies
0=0, 1=1, 2=2....
M
Depth of the
Unit
S = standard depth, B = short depth
Y
Air Flow direc-
tion
R= Connector side to PSU side airflow
F= PSU side to Connector side airflow
R
RoHS C=RoHS5, X=RoHS6
Rack Size Switch Standard/ Short Rail Kit #
50cm to 80cm Short
MIS000083
Standard
MIS000085
38cm to 50cm
Short
MIS000079

Mellanox Technologies IS5030 Specifications

General

Brand	Mellanox Technologies
Model	IS5030
Category	Switch
Language	English

Summary

Installing the Switch in the Rack

Tools and Parts

Lists tools and parts included in the installation kit.

Rack Mounting Procedure

Step-by-step guide for physically installing the switch into the rack.

Grounding the Switch

Initial Switch Configuration

Console Connection and Serial Terminal Setup

Connecting a PC to the console port and configuring serial terminal settings.

Configuration Wizard and IP Setup

Using the wizard for initial IP configuration via DHCP or static settings.

Network Connectivity and Management

Verifying Network Interface Configuration

Checking the status and IP address of the eth0 network interface.

Establishing an SSH Connection

Connecting to the switch remotely via SSH for command-line management.

Accessing the WebUI

Connecting to the switch's web interface for graphical management.

Switch Maintenance

Resetting the Switch

Instructions on how to perform a soft or hard reset of the switch.