Memorex iWakeUp Mi4014 - Setting the Alarm; Alarm Time Setup; Alarm Source Selection; Alarm Frequency Setting

15
OPERATION (CONTINUED)
With the power off, press and hold
either the ALARM 1 button 1 (to set
Alarm 1) or ALARM 2 button 2 (to
set Alarm 2); the Alarm time will
blink in the display.
SNOOZE
1
2
1
If set to Radio (in Step 2), then
while the frequency is blinking,
set the frequency using the
Tune/Skip/Search o 1 or n
2 button.
NOTE: When the alarm time is
reached, the unit will turn on the
band (AM or FM) and the
frequency that you selected.
SNOOZE
1
2
3
Press the ALARM 1 button 1 or
ALARM 2 button 2 again; the
maximum alarm volume level
will blink.
Press the Volume Up 3 and/or
Down 4 button to increase and/or
decrease the maximum alarm
volume level.
Press the ALARM 1 button 1 or
ALARM 2 button 2 yet again.
SNOOZE
3
1
2
4
4
TO SET OR RESET THE ALARM TIME
Within 15 seconds, press the MIN
(Minute) button 1 to set the alarm
minute and the HOUR button 2 to set
the alarm hour. Make sure to set the
correct AM/PM setting.
While the alarm time is blinking,
repeatedly press the MODE button 3 to
select alarm on for radio (FM or AM),
iPod or buzzer.
NOTE: Make sure the corresponding
indicator (RADIO [FM or AM], iPod,
BUZZ) appears in the display.
SNOOZE
1
2
3
2
CONTINUED ON THE NEXT PAGE
All manuals and user guides at all-guides.com
all-guides.com