Two (2) “AAA” size batteries can also be used to
power and/or to provide a backup for the clock
and alarm time for this unit as follows:
1. Open the battery door by pushing in on the
tab, then removing the door.
2. Insert two (2) “AAA” batteries as shown.
Alkaline batteries are recommended for the
longest playing time.
3. Place the battery door back on the
compartment.
NOTES:
• The batteries are used to back-up the clock and alarm times when the AC
adapter is disconnected or there is a power failure.
• The battery indicator will appear or blink in the display when there are no
batteries or the batteries are low and need replacing.
IMPORTANT! See BATTERY PRECAUTIONS on the next page.
7
POWER SOURCE
BATTERY INSTALLATION
AC CONNECTION
Insert the small end of the AC adapter
into the DC IN 12V jack (located on the
rear of the unit). Connect the other end
to a wall outlet having 120V AC, 60 Hz.
AC Adapter, DC 12V Z
NOTES:
• Remove both the DC plug and the
AC-IN plug to disconnect the AC adapter when not in use.
• Only use the supplied AC adapter which has the following specs:
DC 12V Z
To Next Page
Loading...
