- 10 -
INSTALLATION
Installing with the Stand
It is highly recommended that two people take part in removing the TV from the packaging
and installation. The TV can be installed in two ways:
• On a flat surface, using the included stand - See below.
• On a wall, using a VESA-standard wall mount (not included) - See the following page.
The included stand is designed to
support the weight of the TV and
keep it from falling over. However,
the TV can still fall over if: a) placed
on an uneven, unstable, or non-level
surface, or b) pushed, pulled, or
improperly moved. Also, make sure
to give proper clearance as shown in
the image.
1
Place TV flat on table.
2
Install base on the rear of the TV
bottom as shown in ther arrow.
3
Place the stand so the top of
the oval raised stand on base
V corner and the oval of the
bottom of the TV’s back cover
are aligned, then tightly insert the
screws (see figure to make sure it
is installed properly).
4
Insert the AC plug (with the 3
blades) into a conveniently located
AC outlet having 120V, 60Hz.
To Next Page
Loading...
Need help?
General
