8
REMOTE CONTROL
BATTERY INSTALLATION
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
NOTES:
• When there is an obstacle
between the DVD and the
transmitter, the transmitter may
not operate.
•
When direct sunlight, an
incandescent lamp, fluorescent
lamp or any other strong light
shines on the REMOTE
SENSOR of the DVD, the
remote operation may be
unstable.
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in to the Battery Compartment. Reversed
batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible
battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
1.
Remove the Battery Compartment cover by pressing in on the tab and
then lifting the cover off.
2. Install a CR2025 battery, paying attention to the polarity diagram in
the Battery Compartment (positive side up).
3. Replace the Battery Compartment cover.
To Next Page
Loading...
Need help?
General
