Bridgeable & Tri-Mode Operation Memphis Car Audio Power Reference amplifiers
can be used in stereo, bridged, or tri-mode operation. Tri-Mode operation means that pair
of speakers is wired in the conventional stereo manner, while a subwoofer is
simultaneously connected to the bridged terminals of the same two channels. This is
useful for simple 2-channel systems that require a subwoofer in addition to the full-range
speakers.
Brand New Design for 2003 Black textured finish heat sink with black chrome trim
and injection molded end plates, and all the features you need!
Platinum finish connections Ensures solid electrical connections that resist corrosion.
Fully Variable High & Low Pass Crossovers Fully variable crossovers promote
installation ease and save the cost of outboard crossovers. Additionally, they may be
used in conjunction with outboard passive or active crossovers, depending on the
complexity required by the system. The 12dB per octave slope offers steep roll-off above
or below the selected frequency.
Protection Circuitry Against Overload, Short Circuit, Thermal, and Reverse These
protection features are designed to protect the amplifier from misuse, as well as from
common causes of amplifier failure.
What does the little green light mean?
•It means that the amplifier is on, and should be working normally. If the light is not
illuminated, then please consult the trouble shooting section of this manual.
To Next Page
Loading...
