Menuett 800262 - Switching off

EN
36
used for some time, fully charge the
battery, switch o the vacuum cleaner
with the power switch, and store it in a dry
and cool place.
START/STANDBY MODE/SLEEP
MODE/SWITCH OFF
Starting
1. Press the power switch on the side of the
vacuum cleaner.
2. Press
on the vacuum cleaner or
ON/OFF on the remote control to start
vacuum cleaning.
NOTE:
If the vacuum cleaner is in sleep mode
press,
or ON/OFF on the remote control
to activate the vacuum cleaner, and then
press
again. The vacuum cleaner starts
vacuum cleaning automatically.
Standby mode
In standby mode the vacuum cleaner is
activated, but waiting for a command. Follow
the instructions below to put the vacuum
cleaner in standby mode.
1. When vacuum cleaning is in progress,
press
to put the vacuum cleaner in
standby mode.
2. When vacuum cleaning is in progress,
press ON/OFF on the remote control to
switch o the vacuum cleaner.
Sleep mode
To save energy the vacuum cleaner can in sleep
mode only be activated with the button
or the ON/OFF button on the remote control.
Follow the instructions to put the vacuum
cleaner in sleep mode when it is in standby
mode:
1. Press the button on the vacuum
cleaner for 3 seconds.
2. The vacuum cleaner goes automatically
into sleep mode if no command is
received after 15 minutes.
Switching o
1. In standby mode, press the power switch
on the side of the vacuum cleaner.
2. In sleep mode the vacuum cleaner
automatically switches o if no command
is received after 15 minutes and nothing
has been programmed. If the vacuum
cleaner has been programmed it will
remain in sleep mode.
TIMED VACUUM CLEANING
• The vacuum cleaner can be programmed
to automatically start vacuum cleaning
at a set time each day (delay of up to
23 hours).
• If the time is 09:00 and you set the
remote control to 6:30 the vacuum
cleaner will start vacuum cleaning after
6 hours and 30 minutes, i.e. at 15:30.
It will then start vacuum cleaning at 15:30
every day, unless the user switches it o
with the power switch underneath.
NOTE:
The vacuum cleaner always starts at the set
time, unless the power switch underneath is
in the o position.
Programming via
the remote control
Follow the instructions below to program a
schedule with the remote control:
1. Press the ON/OFF button to activate the
vacuum cleaner and press PLAN to go to
programming mode.