Menuett 800262 - Maintenance

EN
37
2. Use the direction button to enter the
required values. Press ˄and ˅ to set the
digits. Press ﹤ and ﹥ to switch between
setting hours and minutes.
3. Press ON/OFF to save the setting.
4. To delete the programmed schedule, set
00:00 on the remote control or press the
PLAN button on the remote control for 3
seconds in programming mode.
NOTE:
• In programming mode an audio prompt
will be heard every time a button is
pressed.
• The vacuum cleaner starts vacuum
cleaning at the programmed time every
time by means of the vacuum cleaner’s
own clock.
• The vacuum cleaner can only be
programmed in standby mode or during
charging.
VACUUM CLEANING MODES
Automatic vacuum cleaning
The vacuum cleaner vacuum cleans the room
automatically and adapts to the surroundings.
Press
or ON/OFF on the remote control to
start vacuum cleaning.
FIG. 10
Spot vacuum cleaning
Spot vacuum cleaning is activated in the
following situations:
1. When a very dirty area is detected.
2. When the SPOT button on the remote
control is pressed.
FIG. 11
NOTE:
We recommend activating spot vacuum
cleaning in very dirty areas.
Edge vacuum cleaning
When vacuuming is in progress, press the
MODE button to activate edge vacuum
cleaning. The vacuum cleaner vacuums along
walls and obstacles.
FIG. 12
NOTE:
Mode 1 – Spot vacuum cleaning.
Mode 2 – Random vacuum cleaning.
Mode 3 – Edge vacuum cleaning.
Mode 4 – S line vacuum cleaning.
MAINTENANCE
CLEANING
Side brushes
1. Check the side brushes when necessary
and replace them if they are damaged.
The maximum lifespan of the side brushes
is about 12 months.
2. If the bristles on the side brushes have
bent they can be straightened out by
putting them in hot water for about 5
seconds.
IMPORTANT:
• Remove the side brush from the vacuum
cleaner before putting it in hot water.
• When replacing the side brushes make
sure to put the brush marked L on the
fastener marked L on the vacuum
cleaner, and the brush marked R on the
fastener marked R.
Dust container and lter
Empty and clean the dustbin according to the
instructions below after use:
1. Press the PUSH button to open the cover.
2. Remove the dustbin.