Introduction and technical specifications 1---1......................
Foreword 1---1..........................................................
Machine presentation 1---2...............................................
Machine specification 1---2...............................................
N a m e p l a t e 1 --- 2........................................................
Dimensions 1---6........................................................
Functional parts 2---1............................................
SHARK 282 model 2---1.................................................
Cutting head 2---2.......................................................
Vice 2 --- 2..............................................................
C o n t r o l Pa n e l 2 --- 3......................................................
Tu r n t a b l e 2 --- 3..........................................................
Base 2 --- 4..............................................................
Safety and accident prevention 3---1................................
U s e o f t h e m a c h i n e 3 --- 1.................................................
General recommendations 3---2...........................................
Recommendations to the operator 3---3....................................
Machine safety devices 3---5..............................................
Reference standards 3---5................................................
Protection against accidental contact with the blade 3---6......................
Electrical equipment 3---6................................................
Emergency devices 3---7..................................................
Noise level of the machine 3---8...........................................
Noise level measurement 3---8............................................
Noise level values 3---8...................................................
Vibration emission 3---9..................................................
Electromagnetic compatibility 3---9........................................
Machine installation 4---1........................................
Packaging and storage 4---1...............................................
Anchoring the machine 4--- 4..............................................
Minimum requirements 4---4..............................................
C h e c k l i s t 4 --- 5..........................................................
Balancing the cutting head 4---6...........................................
Connection to the compressed---air supply (MA version) 4---6..................
Connection to the power supply 4---7.......................................
Description of machine operation 5---1.............................
Description of the control panel 5---1......................................
Basic instructions for carrying out a cutting operation cycle 5---4................
Manoeuvring the cutting head 5---4........................................
Clamping the work piece in the vice 5---5...................................
Clamping the work piece in the Automatic Vice (MA version) 5---5.............
Rapid vice positioning 5---6...............................................
Rapid translation of the vice 5---6..........................................
Wi d t h o f c u t 5 --- 7.......................................................
Preliminary check list for cutting operation 5---8.............................
Manual operating cycle 5---8..............................................
CCS (Cut Control System) functioning cycle 5---11............................
A n g l e d c u t s 5 --- 1 3........................................................
Angled cuts 45° to the left 5---13...........................................
Angled cuts 60° to the left 5---14...........................................
To Next Page
Loading...
