MEP SHARK 282 - Page 7

Oil for lubricant/coolant fluid 8---4.........................................
Oils for spray mist system (optio nal) 8---4...................................
Cutting speed and choice of tools 9---1..............................
Cutting speed 9---1......................................................
Standard machine 9---1..................................................
Machine with 4/8 pole motor (optional) 9---1................................
Machine with Inverter (optional) 9---2......................................
Choice of blade 9---3....................................................
Saw tooth pitch 9---3.....................................................
Cutting speed and downstroke speed 9---4..................................
Ty p e s o f s w a r f : 9 --- 4.....................................................
Lubricant/coolant fluid 9---5..............................................
Blade structure 9---6.....................................................
B l a d e t y p e s 9 --- 6........................................................
C o n v e n t i o n a l r a k e 9 --- 7..................................................
Po s i t i v e r a k e 9 --- 7.......................................................
Va r i a b l e p i t c h 9 --- 7......................................................
Variable pitch blades with 0° cutting angle 9---8..............................
Variable pitch with positive rake (from 9 to 10 degrees) 9---8...................
Set: 9 --- 8...............................................................
Standard or splayed set 9---8..............................................
U n d u l a t e d s e t 9 --- 9......................................................
Alternating grouped sets 9---9.............................................
A l t e r n a t i n g s e t 9 --- 9.....................................................
Blade selection table relating to cutting speed and downstroke speed 9---10.......
Classification of steels 9---11...............................................
Classification of steels 9---12...............................................
Troubleshooting 10---1............................................
Troubleshooting blade and cutting problems 10---1............................
Troubleshooting machine faults 10---8.......................................
Accessory Installation 11---1.......................................
Automatic vice kit 11---1..................................................
Blade 1 1 --- 2.............................................................
Cut Control System 11---2.................................................
Electronic rpm variator (inverter) 11---3.....................................
Rodmarkedoffinmillimetres 11---5........................................
Roller table 11---6........................................................
Support for the roller platform on t he feeding/discharging side 11---7.............
Discharge side roller table adaptorAdattatore pianale a rulli lato scarico 11---8....