High beam
#
To switch on: turn the light switch to the
L or à position.
#
Push the combination switch in the direction
of arrow 1.
When the high beam is activated, the L
low beam indicator lamp will be deactivated
and replaced by the K high beam indica‐
tor lamp.
#
To switch off: push the combination switch
in the direction of arrow 1 or pull in the
direction of arrow 3.
High-beam flasher
#
Pull the combination switch in the direction
of arrow 3.
Turn signal light
#
To indicate briefly: press the combination
switch briefly to the point of resistance in the
direction of arrow 2 or 4.
The corresponding turn signal indicator will
flash three times.
#
To indicate permanently: press the combi‐
nation switch beyond the point of resistance
in the direction of arrow 2 or 4.
Vehicles with Active Lane Change Assist:
R
Indicator operation activated by the driver
can extend for the duration of the lane
change.
R
If the driver indicated directly beforehand
but a lane change was not immediately
possible, the turn signal indicator may
activate automatically.
Activating/deactivating the hazard warning
lamps
#
Press button 1 .
The hazard warning lamps will switch on auto‐
matically if:
R
the airbag has been deployed.
When the turn indicator is activated, the hazard
warning lamps are interrupted.
Light and visibility
139
To Next Page
Loading...
Need help?
General
