!
WARNING
Incorrect cable lubrication can cause hydraulic lock, leading to serious
injury or death from loss of boat control. Completely retract the end of the
steering cable before applying lubricant.
a - Fitting
b - Steering cable end
3. Lubricate the following with lightweight oil.
• Steering link rod pivot points ‑ Lubricate pivot points.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision 2‑4‑C with
PTFE.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE Driveshaft bearing 92-802859A 1
IMPORTANT: It is important not to use a general all‑purpose grease for this
bearing. The lubricant recommended is a water‑resistant grease of the proper
consistency for this application. If a substitute is used, be sure that it is
water‑resistant.
• Driveshaft bearing
i. Pull the vent hose off of the grease fitting.
ii. Pump in grease through the grease fitting until excess grease
starts to exit the vent hose.
MAINTENANCE
eng 97
To Next Page
Loading...
Need help?
General
