• Steering cable grease fitting (if equipped) ‑ Rotate steering wheel to
fully retract the steering cable end into the outboard tilt tube. Lubricate
through fitting.
!
WARNING
Incorrect cable lubrication can cause hydraulic lock, leading to serious
injury or death from loss of boat control. Completely retract the end of the
steering cable before applying lubricant.
a - Fitting
b - Steering cable end
3. Lubricate the following with lightweight oil.
• Steering link rod pivot points ‑ Lubricate pivot points.
Checking Power Trim Fluid
1. Tilt the outboard to the full up position and engage the tilt support lever.
2. Remove the fill cap and check the fluid level. The fluid level should be
even with the bottom of the fill hole. Add Quicksilver or Mercury Precision
Lubricants Power Trim and Steering Fluid. If not available, use automotive
automatic transmission fluid (ATF).
MAINTENANCE
eng 99
To Next Page
Loading...
Need help?
General
