Tube Ref No. Description Where Used Part No.
7
Loctite® 271
Threadlocker
Tiller handle screw threads 92-809819
Description Nm lb‑in. lb‑ft
Upper mount locknut 27.0 – 19.9
Tiller handle screws 40.0 – 29.5
Driveshaft Housing Removal
1.
Completely remove the driveshaft housing covers, including disconnecting the cowl‑mounted tilt switch (if equipped) and
the power tilt pump wires (if equipped). Refer to Driveshaft Housing Covers.
2.
Remove the front cowl. Refer to Front Cowl.
3.
Remove the gear housing. Refer to Section 6A ‑ Gear Housing Removal.
4.
Remove the powerhead. Refer to Section 4A ‑ Powerhead Removal.
5.
Remove the lower mount. Refer to Lower Mount.
6. Remove the two upper mount nuts.
7. Remove the driveshaft housing from the steering arm.
a - Nut (one each side)
b - Steering arm
8. Remove the powerhead gasket.
9.
Remove the driveshaft seal.
10. Remove the rubber seal from the driveshaft housing.
a - Powerhead gasket
b - Dowel pin
c - Driveshaft seal
d - Rubber seal
Clamp/Swivel Bracket and Driveshaft Housing
Page 5A-46 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017
To Next Page
Loading...
Need help?
General