FEATURES AND CONTROLS
92 eng
Synchronizing Helms Prior to Transfer
Pressing the "TRANSFER" button allows the boat operator 10
seconds to match up the control handle settings at the new helm
with the handle settings that are at the old (to be inactive) helm.
If the handles are not matched, the neutral lights will flash. The
light blinks faster as the handles are nearing match position.
Once the light stays on continuously, the handles are matched
and the button can be pressed again to complete the transfer.
This completes the transfer process, and gives control to the
new station. If the helm transfer is not completed within 10
seconds, the action will be cancelled.
Warning System
The outboard warning system incorporates a warning horn inside
the boat. The warning horn is located under the dash within the
wiring harness.
WARNING HORN SIGNALS
When the key switch is turned to the "ON" position, the horn will
turn on for a moment as a test to show the horn is working.
The warning horn will emit either a continuous beep or
intermittent short beeps. This will alert the operator and help
identify the following listed situations. For visual display of the
specific engine functions and for additional engine data, refer to
SmartCraft Product information, following.
Warning Horn
Function Sound Description
Start up One beep Normal system test
Low oil
reserve
Four beeps
every 2
minutes
Oil level is low in the engine mounted oil
reservoir. Refill the engine mounted oil
reservoir along with the remote oil tank.
Refer to Fuel & Oil.
Water in fuel Four beeps
every 2
minutes
Water in the fuel filter chamber reaches the
full level. Water can be removed from the
chamber. Refer to Maintenance ‑ Fuel
System for water removal.
To Next Page
Loading...
Need help?
General