EasyManuals Logo

Mercury 200 OptiMax DTS User Manual

Mercury 200 OptiMax DTS
157 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
TROUBLESHOOTING
eng 139
Starter Motor Will Not Crank the Engine
POSSIBLE CAUSES
Lanyard stop switch not in "RUN" position.
Blown 5 amp fuse. Check DTS power harness circuit fuse.
Refer to Maintenance section.
Outboard is not shifted to neutral position.
Shift actuator failure. "Gear Shift Diff" error message shown
on System View. Refer to Maintenance section.
Weak battery or battery connections are loose or corroded.
Ignition key switch failure.
Wiring or electrical connection faulty.
Starter motor solenoid or slave solenoid failure.
Engine Will Not Start
POSSIBLE CAUSES
Lanyard stop switch not in "RUN" position.
Battery not fully charged.
Incorrect starting procedure. Refer to Operation section.
Old or contaminated fuel.
Fuel is not reaching the engine.
Fuel tank is empty.
Fuel tank vent not open or restricted.
Fuel line is disconnected or kinked.
Primer bulb not squeezed.
Primer bulb check valve is faulty.
Fuel filter is obstructed. Refer to Maintenance section.
Fuel pump failure.
Fuel tank filter obstructed.
Open 20 amp fuse. Check fuses, refer to Maintenance
section.
Threaded connection of an air hose is loose.
Ignition system component failure.

Table of Contents

Other manuals for Mercury 200 OptiMax DTS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 OptiMax DTS and is the answer not in the manual?

Mercury 200 OptiMax DTS Specifications

General IconGeneral
BrandMercury
Model200 OptiMax DTS
CategoryBoat
LanguageEnglish

Related product manuals