MAINTENANCE
eng 113
4. Wax the surface using a non‑abrasive automotive polish
(polish designed for clear coat finishes). Remove the applied
wax by hand using a clean soft cloth.
Alternator Belt Inspection
1. Inspect the alternator belt and have it replaced by an
authorized dealer if any of the following conditions are
found.
a. Cracks or deterioration in the rubber portion of the belt.
b. Belt surfaces rough or uneven.
c. Signs of wear on edges or outer surfaces of belt.
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is
off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for
leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
To Next Page
Loading...
