FEATURES AND CONTROLS
98 eng
TILTING TO FULL UP POSITION
Tilt At Helm
NOTE: The trim/tilt switch will remain active for 15 minutes after
the ignition key switch has been turned off.
1. If the ignition key switch has been turned off for over 15
minutes, turn it to the "ON" position.
2. Press the trim/tilt switch to the up position. The outboard will
tilt up until the switch is released or it reaches its maximum
tilt position.
Tilt At Engine
The cowl mounted auxiliary tilt switch can be used to tilt the
outboard with the key switch in the "OFF" position.
1. Engage the tilt support lever, by rotating knob to bring the
support lever upward.
2. Lower outboard to rest on the tilt support lever.
3. Disengage the tilt support lever, by raising the outboard off
the support lever and rotating the tilt support lever down.
Lower the outboard.
a - Tilt support lever
b - Knob
MANUAL TILTING
If the outboard cannot be tilted using the power trim/tilt switch,
the outboard can be manually tilted.
NOTE: The manual tilt release valve must be tightened before
operating the outboard to prevent the outboard from tilting up
during reverse operation.
To Next Page
Loading...
