MAINTENANCE
eng 117
!
WARNING
Improper fasteners or improper installation procedures can
result in loosening or disengagement of the steering link rod.
This can cause a sudden, unexpected loss of boat control,
resulting in serious injury or death due to occupants being
thrown within or out of the boat. Always use required
components and follow instructions and torque procedures.
a - Special washer head bolt (10‑849838)
b - Flat washer (2)
c - Nylon insert locknut (11‑826709113)
d - Nylon insert locknut (11‑826709113)
Description Nm lb‑in. lb‑ft
Special washer head bolt 27 20
Nylon insert locknut "d" 27 20
Nylon insert locknut "c"
Tighten until it seats, then back off 1/4
turn
Assemble steering link rod to steering cable with two flat
washers and self‑locking nylon insert locknut. Tighten locknut
until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head
bolt and self‑locking nylon insert locknut. First torque bolt, then
torque locknut to specifications.
To Next Page
Loading...
