Mercury 225 OptiMax DTS - Installing DTS Command Module and Harness - Single Engine

200/225 OPTIMAX DTS
Page 16 / 42 90-10234050
DUAL HELM
3978
a
b
c
d
e
c
a - Helm 2 (upper helm)
b - Helm 1 (lower helm)
c - 14 pin data harness
d - Dual helm adapter (Y harness)
e - Clamp or cable tie
Installing DTS Command Module and Harness - Single Engine
HARNESS INSTALLATION
• Locate a routing path for the harness connections so they reach their installation
points.
• Inspect the routing path to make sure surfaces are free of any sharp edges or burrs
that could cut the harness.
• Fasten and support the harness with clamps or cable ties along the routing path.