Mercury 25 4-Stroke - Page 45

OPERATION
41
ob00348
2. Squeeze the fuel line primer bulb several times until it feels firm.
ob00349
IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb after engine has warmed up.
3. Set the lanyard stop switch to RUN position. Refer to General Information - Lanyard Stop Switch.
ob00350
4. Shift outboard to neutral (N) position.
N
ob00351
5. Models without power trim - Position the tilt lock lever down to the lock position.
ob00625
a
b
6. Position the remote control neutral fast idle speed feature as follows:
• Cold Engine - Move the neutral fast idle speed feature to the fully closed position.
• Warm Engine - Advance the neutral fast idle speed feature on the remote control to the maximum fast
idle speed position. After engine has started, immediately reduce idle speed to normal.