Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacity is approximately 3.0 liter (3 quarts).
OIL CHANGING PROCEDURE
1. Tilt the outboard up to the trailer position.
2. Turn the steering on the outboard so that the drain hole is facing downward. Remove drain plug and drain
engine oil into an appropriate container. Lubricate the seal on the drain plug with oil and reinstall.
CHANGING OIL FILTER
1. Place a rag or towel below the oil filter to absorb any spilled oil.
2. Unscrew old filter by turning the filter to the left.
3. Clean the mounting base. Apply film of clean oil to filter gasket. Do not use grease. Screw new filter on until
gasket contacts base, then tighten 3/4 to 1 turn.
OIL FILLING
1. Remove the oil fill cap and add oil to proper operating level.
2. Idle engine for five minutes and check for leaks. Stop engine and check oil level on dipstick. Add oil if
necessary.
To Next Page
Loading...
