ENGINE INSTALLATION
104
The outboard must be secured to the transom with the two transom
bracket clamp screws and four 13 mm (1/2 in.) diameter mounting
bolts and locknuts provided. Install two bolts through the upper set
of mounting holes and two bolts through the lower set of mounting
slots.
a - Bolt
b - Transom clamp bolt
c - Washer
d - Nut
Steering Bracket, Steering Cable Installation
1. Lubricate entire cable end with 2‑4‑C with Teflon.
Tube Ref No. Description Where Used Part No.
95
2-4-C with Teflon Steering cable end 92-802859A1
2. Install the cable seal onto the tilt tube.
3. Install the steering bracket with two washers and two
30 x 80 mm bolts. Tighten the steering bracket bolts to the
specified torque.
To Next Page
Loading...
