MAINTENANCE
84
Timing Belt Inspection
1. Inspect the timing belt and have it replaced by an authorized
dealer if any of the following conditions are found.
a. Cracks in the back of the belt or in the base of the belt teeth.
b. Excessive wear at the roots of the cogs.
c. Rubber portion swollen by oil.
d. Belt surfaces roughened.
e. Signs of wear on edges or outer surfaces of belt.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
Lubricants Anti‑Corrosion Grease or 2‑4‑C with Teflon.
Tube Ref No. Description Where Used Part No.
94
Anti-Corrosion
Grease
Driveshaft bearing 92-802867A1
95
2-4-C with Teflon Driveshaft bearing 92-802859A1
• Driveshaft bearing
IMPORTANT: It is important not to use a general all purpose
grease for this bearing. The lubricant recommended is a water
resistant grease of the proper consistency for this application. If a
substitute is used, be sure that it is water resistant and of the same
consistency.
i. Pull the vent hose off of the grease fitting.
To Next Page
Loading...
