Mercury 25 Jet 4-Stroke - Page 95

MAINTENANCE
89
OIL CHANGING PROCEDURE
1. Tilt the outboard up to the trailer position.
2. Turn the steering on the outboard so that the drain hole is
facing downward. Remove the drain plug and drain engine oil
into an appropriate container. Lubricate the seal on the drain
plug with oil and reinstall.
a
24854
a - Drain plug
CHANGING OIL FILTER
1. Place a rag or towel below the oil filter to absorb any spilled
oil.
2. Unscrew the old filter by turning the filter to the left.
9735
3. Clean the mounting base. Apply a film of clean oil to the filter
gasket. Do not use grease. Screw the new filter on until the
gasket contacts the base, then tighten 3/4 to 1 turn.