5. Thread the remote control cables through the terminal eyes at a distance
of more than 16 mm (0.63 in.). Securely lock the terminal eyes with the
locknut.
a - Terminal eyes
b - Locknut
6. Press the neck of the shift remote control cable down into the clamp on
the housing of the remote control box. Connect the terminal eye to the
shift arm with the pin and E‑ring. Insert a grommet, supplied with the
remote control box, into the clamp.
a - Grommet
b - Shift arm pin
c - E‑ring
d - Shift arm
To Next Page
Loading...
