Mercury 50 - Quicksilver Side; Remote Control Components

QUiCKSiLVER SIDE MOUNT
REMOTE CONTROL COMPONENTS
1 Neutral Lock Bar - prevents accidental
shift and throttleengagement. Bar must be
squeezed before control handle can be
moved, from NEUTRAL.
2 Control Handle - controls forward,
reverse
motiori and engine speed.
3 Ignition/Choke Switch - turns engine
ON and OFF actuates electric starter
motor actuaies carburetor
enr~chener
and sounds alarm horn momentarily to test
warning circu ts
4 Lanyard Stsp Sw~tch - Refer to page 1
for explanation The lanyard cord/clip,
when used wlth the lanyard stop switch
MUST BE connected to boat driver Should
driver be unable to reach steering wheel or
remote contrcl, the lanyard
cord/cllp will
be pulled
from lanyard stop swrtch and the
engine
w~ll st ut OFF This lanyard stop
sw~tch SHOUl D NOT BE USED as normal
engine
shut-otf
IMPORTANT: The Lanyard Stop Switch
can be repositioned to RUN with orwithout
lanyard
cordlclip so that engine can be
5 Engine can I,e restarted with or without
lanyard
cord/cl$p Installed by simply push -
ing switch up to run position If necessary
push switch
dom w~th key to reinstall clip
6 F A S T I D L E L E V E R - AMWS engine
throttle
advartxment, without shifting
gears, to assist engine starting.
7 THROTTLE FRIC7 ION Adjustmerit
Knob - Adjusrs control handle frlction so
that boat
spew can be set and driver does
not have to
hol I handle Turn knob clock -
wise to increas? frictio? DO NOT thread
knob all the
wa] out
8 Tachometer Receptacle - Wiring har -
ness connector for optional tachometer.
9 Trlm/Tilt Snftch (For Outboards wlth
Power Trim) - -r~m outaoard out (up) by
pressing up
CII switch tr~m outboard in
(down) by pres
dng do#n on swltch
10 Warning Horn Located in Remote
Control. Refer
to " Operation " - " Warning
Horn
Operatior" following.
restarted.
OPERATION
MODELS
WITH REMOTE CONTROL
WARNING HORN OPERATION
ACAUTION
This outboard is equipped with a warning
the warning horn fails to sound
system to signal engine overheat and low
tarily when the key switch is turned from
oil level in the oil injection system.
the "OFF" position to the " ON" position or
The warning horn is located inside of side
continually sounds, see an Authorized
mount remote control. If boat is equipped
Dealer. DO NOT operate the engine.
with a panel orconsole remotecontrol, the
warning horn
IS incorporated behind the
The warning system gives the following
key switch in the key switch wiring har
-
indications:
ness.
MOMENTARY BEEP (when key switch is
Each
timethe key switch isturned form the
turned on)
- circuit test of warning system.
" OFF " position to the " ON " position the
STEADY BEEP - Engine is overheated,
warnina horn will sound momentarily. This
d
indicates thatthe warning system will func- . INTERMITTEN I BEEP - 011 in~ectron oil
tion when the tngine is running
level