EasyManuals Logo

Mercury 50 User Manual

Mercury 50
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
MAINTENANCE
56
ob01604
2. Attach a water hose to the flushing attachment. Turn on the water and adjust the flow so water is leaking
around the rubber cups to ensure the engine receives an adequate supply of cooling water.
ob00570
3. Start the engine and run it at idle speed in neutral shift position.
IMPORTANT: Do not run engine above idle when flushing.
4. Adjust water flow (if necessary) so excess water continues leaking out from around the rubber cups to ensure
the engine is receiving an adequate supply of cooling water.
ob00571
5. Check for a steady stream of water flowing out of the water pump indicator hole. Continue flushing the
outboard for 3 to 5 minutes, carefully monitoring water supply at all times.
6. Stop the engine, turn off the water, and remove the flushing attachment. Reinstall the propeller.
Top Cowl Removal And Installation
REMOVAL
1. Unlock the rear latch by pushing lever down.
ob00368
2. Lift rear of cowl and disengage front hook.

Table of Contents

Other manuals for Mercury 50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 50 and is the answer not in the manual?

Mercury 50 Specifications

General IconGeneral
Horsepower50 hp
Cylinders3
SteeringRemote
StartingElectric
Displacement995 cc
Fuel Induction SystemEFI (Electronic Fuel Injection)
Alternator Output18 amp
Shaft Length20" / 508 mm
Dry Weight112 kg
Engine Type4-Stroke

Related product manuals