Mercury 50 User Manual

MAINTENANCE
77
Assemble steering link rod to engine with special washer head bolt,
locknut and spacer. First torque bolt to specifications, then torque
locknut to specifications.
3086
a
b
c
e
d
a - Special washer head bolt (10‑856680)
b - Nylon insert locknut (11‑826709113)
c - Spacer
d - Flat washers
e - Nylon insert locknut (11‑826709113)
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "b" 27 20
Nylon insert locknut "e" Tighten until seats, then back off 1/4 turn
Fuse Replacement ‑ Electric Start Models
IMPORTANT: Always carry spare SFE 20 amp fuses.
The electric starting circuit is protected from overload by an SFE
20 amp fuse. If the fuse is blown, the electric starter motor will not
operate. Try to locate and correct the cause of the overload. If the
cause is not found, the fuse may blow again.

Mercury 50 Specifications

General

Horsepower	50 hp
Cylinders	3
Steering	Remote
Starting	Electric
Displacement	995 cc
Fuel Induction System	EFI (Electronic Fuel Injection)
Alternator Output	18 amp
Shaft Length	20" / 508 mm
Dry Weight	112 kg
Engine Type	4-Stroke