GENERAL INFORMATION
eng 21
Important Safety Information: The purpose of a lanyard stop
switch is to stop the engine when the operator moves far enough
away from the operator's position to activate the switch. This
would occur if the operator accidentally falls overboard or moves
within the boat a sufficient distance from the operator's position.
Falling overboard and accidental ejections are more likely to
occur in certain types of boats such as low sided inflatables,
bass boats, high performance boats, and light, sensitive handling
fishing boats operated by a hand tiller. Falling overboard and
accidental ejections are also likely to occur as a result of poor
operating practices such as sitting on the back of the seat or
gunwale at planing speeds, standing at planing speeds, sitting
on elevated fishing boat decks, operating at planing speeds in
shallow or obstacle infested waters, releasing your grip on a
steering wheel or tiller handle that is pulling in one direction,
drinking alcohol or consuming drugs, or daring high speed boat
maneuvers.
While activation of the lanyard stop switch will stop the engine
immediately, a boat will continue to coast for some distance
depending upon the velocity and degree of any turn at shut
down. However, the boat will not complete a full circle. While the
boat is coasting, it can cause injury to anyone in the boat's path
as seriously as the boat would when under power.
We strongly recommend that other occupants be instructed on
proper starting and operating procedures should they be
required to operate the engine in an emergency (e.g. if the
operator is accidentally ejected).
!
WARNING
If the operator falls out of the boat, stop the engine immediately
to reduce the possibility of serious injury or death from being
struck by the boat. Always properly connect the operator to the
stop switch using a lanyard.
To Next Page
Loading...
Need help?
General
