MAINTENANCE
72 eng
Description Nm lb‑in. lb‑ft
Nylon insert locknut "c"
Tighten until it seats, then back off 1/4
turn
Assemble steering link rod to steering cable with two flat
washers and self‑locking nylon insert locknut. Tighten locknut
until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head
bolt and self‑locking nylon insert locknut. First torque bolt, then
torque locknut to specifications.
Fuse Replacement
IMPORTANT: Always carry spare 5 and 20 amp fuses.
The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate
and correct the cause of the overload. If the cause is not found,
the fuse may blow again.
To Next Page
Loading...
