4. Turn the key switch to the "ON" position again for three seconds.
5. Continue this procedure until the fuel line primer bulb stays firm.
Installation Specifications
a - Minimum transom opening
b - Engine centerline for dual engine ‑ 66.0 cm (26 in.)
Minimum Transom Opening
Single engine 84.2 cm (33 in.)
Dual engine 149.9 cm (59 in.)
Lifting the Outboard
!
WARNING
Improperly supporting an engine during lifting can result in the engine falling,
causing serious injury or death. Before lifting the engine, verify that the lifting
ring is threaded into the flywheel for a minimum of five turns and that the
hoist has the correct lifting capacity for the engine weight.
To lift the outboard:
1. Remove the cowl from the outboard.
OUTBOARD INSTALLATION
eng 121
To Next Page
Loading...
