Mercury 75 - Drilling Outboard Mounting Holes

2.
Fasten outboard to the transom at this height. Refer to Fastening the
Outboard.
22403
Drilling Outboard Mounting Holes
IMPORTANT: Before drilling any mounting holes, carefully read Determining
Recommended Outboard Mounting Height and install outboard to the
nearest recommended mounting height.
1. Mark four mounting holes on the transom using the transom drilling
fixture.
a - Drill guide holes
b - Transom drilling fixture
c - Transom centerline
2757
a
a
b
c
OUTBOARD INSTALLATION
eng 127