Mercury 8 User Manual

OPERATION
66
1. Open the fuel tank vent screw in the filler cap on manual
venting type tanks.
19748
2. Position the fuel line primer bulb so the arrow on the side of
the bulb is pointing up. Squeeze the fuel line primer bulb
several times until it feels firm.
IMPORTANT: To prevent engine flooding, do not squeeze the
primer bulb after engine has warmed up.
27348
3. Set the lanyard stop switch to "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791
4. Set the remote control handle to neutral position.

Mercury 8 Specifications

General

Full Throttle RPM	5000-6000 RPM
Cylinders	2
Gear Ratio	2.08:1
Horsepower	8 HP
Starting	Manual
Shaft Length	15 in, 20 in
Fuel Tank Capacity	External