EasyManuals Logo

Mercury 8 User Manual

Mercury 8
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
MAINTENANCE
75
Replace spark plugs at first 100 hours or first year. After that,
inspect spark plugs every 100 hours or once yearly. Replace
spark plugs as needed. See Spark Plug Inspection and
Replacement.
Inspect thermostat visually for corrosion and broken spring.
Make sure thermostat closes completely at room temperature.
1.
Check fuel line filter for contaminants. See Fuel System.
Check corrosion control anodes. Check more frequently when
used in salt water. See Corrosion Control Anode.
Check and adjust valve clearance, if necessary.
1.
Drain and replace gearcase lubricant. See Gearcase
Lubrication.
Check power tilt fluid. See Checking Power Tilt Fluid.
Lubricate splines on the driveshaft.
1.
Remote control models ‑ Check control cable adjustments.
1.
Inspect timing belt. See Timing Belt Inspection.
Check tightness of bolts, nuts, and other fasteners.
Check cowl seals to make sure seals are intact and not
damaged.
Check internal cowl sound reduction foam (if equipped) to
make sure foam is intact and not damaged.
Check that the intake silencer (if equipped) is in place.
Check that the idle relief muffler (if equipped) is in place.
Check for loose hose clamps and rubber boots (if equipped)
on the air intake assembly.
EVERY 300 HOURS OF USE OR THREE YEARS
Replace water pump impeller (more often if overheating
occurs or reduced water pressure is noted).
1.
BEFORE PERIODS OF STORAGE
Refer to Storage procedure. See Storage section.
1. These items should be serviced by an authorized dealer.

Table of Contents

Other manuals for Mercury 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 8 and is the answer not in the manual?

Mercury 8 Specifications

General IconGeneral
Full Throttle RPM5000-6000 RPM
Cylinders2
Gear Ratio2.08:1
Horsepower8 HP
StartingManual
Shaft Length15 in, 20 in
Fuel Tank CapacityExternal

Related product manuals