DTS DUAL CONSOLE REMOTE CONTROL WITH CAN TRACKPAD
Page 2 / 17 90-889224 MAY 2006
Remote Control Installation
Required Mounting Clearances for DTS Dual Handle Control with CAN Trackpad
a - Hand clearance
Locating and Drilling Mounting Area for DTS Single/Dual Handle Console Control
1. Locate area of boat where the remote control is to be mounted. Allow sufficient
clearance for handle movement and clearance for the wiring.
2. Select the correct template for mounting application.
3. Place template over mounting area; cut and drill as instructed on template.
To Next Page
Loading...